Type: Inflatable PVC boat with a flat bottom and a prefabricated floor. Collapsible.
Class: motor inflatable boat with oars.
For three people. It consists of three hermetic compartments (sealed cylinders) that make up the inflatable boat's frame. The partitions between the hermetic compartments are designed like bags. This is for your safety. If one of the boat's hermetic compartments is punctured, the bag-shaped partitions move in the direction of the puncture. This maintains pressure in the damaged compartment, keeping the boat afloat. You and your belongings will be safe, as two of the hermetic compartments remain sealed.
Length 3.00 m, width 1.50 m, cylinder diameter 42 cm. Weight 28 kg. Load capacity up to 320 kg. Load capacity is always measured with one deflated pressurized compartment, simulating its puncture.
It is possible to install a motor with a maximum permissible power of 5 hp with a standard 38 cm leg.
The packing bag measures 1.15 x 0.3 x 0.4 m. The bag has plenty of room to accommodate a deflated boat.
The boat is made of 5-layer reinforced PVC boat fabric with a material density of 1100 grams per square meter. The fabric is resistant to frost, frequent kinking, and mechanical damage. No special storage conditions are required.
The fabric bottom is flat. On the bottom lies a slatted mat consisting of five wide wooden segments (flooring).
A special rib with a protruding rib is placed around the perimeter to protect the sides from mechanical damage. The protruding rib cuts off spray while the boat is underway.
Two adjustable benches (also known as seats or berths) are attached to special soft rails along the top of the boat's buoyancy tubes. This feature offers enhanced usability and is especially convenient for those of a different height.
The inflated boat is very easy to transport. Three handles are attached to the bow and cones for easy transport. You can easily reel in the anchor rope using any of them. These handles make it very easy for two people to carry the boat (front and back). The bow handle is located below the fender for easy transport. It also serves as a towing cleat.
The boat is equipped with spray gussets at the corners between the rudder tube and the rear wall of the transom. These gussets help to deflect the splashing water that occurs when the boat is in reverse.
The end and sides of the fixed transom are protected by pads. These pads protect the inflatable boat from mechanical damage caused by the motor.
All wooden elements are made of moisture-resistant marine plywood, either Russian or Finnish. Hardwoods are used throughout, including oak, acacia, and birch.
The basic kit includes: a boat, benches, floorboards, an instruction manual, a 6.5-liter foot pump, a pair of aluminum sealed collapsible oars, a field repair kit (a tube of glue and a piece of uniform boat fabric), a packing bag, a passport, and a warranty card.