The AquaStar C-320 inflatable boat has a flat bottom and a prefabricated floor. Collapsible.

Class: motor inflatable boat with oars.

The boat has a passenger capacity of three. It consists of three hermetic compartments (sealed cylinders) that make up the inflatable boat's frame. Between the hermetic compartments, the bulkheads are designed like a bag, ensuring your safety. If one of the boat's hermetic compartments is punctured, the bag-shaped bulkheads are deployed in the direction of the breach. This maintains pressure in the damaged compartment, and the boat remains afloat. You and your belongings will be safe, as two of the hermetic compartments remain sealed.

It is planned to install a motor with a maximum permissible power of 6 hp with a standard leg of 38 cm.

Length 3.20 m, width 1.50 m, cylinder diameter 43 cm. Weight 30 kg. Load capacity up to 360 kg. Load capacity is always measured with one deflated pressurized compartment, simulating its puncture.

The packing bag measures 1.15 x 0.3 x 0.4 m. The bag has plenty of room to accommodate a deflated boat.

The boat is made of 5-layer reinforced PVC boat fabric with a material density of 1100 grams per square meter. The fabric is particularly resistant to frost, frequent kinking, and mechanical damage. There are no special storage requirements for the boat.

The fabric bottom is flat. On the bottom lies a slatted mat consisting of five wide wooden segments (flooring).

A special rib with a protruding rib is placed around the perimeter to protect the sides from mechanical damage. The protruding rib cuts off spray while the boat is underway.

It has two adjustable seats that can be adjusted lengthwise along the boat. They are attached to special soft rails (guides) above, along the boat's buoyancy tubes. This feature offers enhanced usability and is especially convenient for those of non-standard height. When inflated, the boat is very easy to transport. Three handles are attached to the bow and cones for easy transport. You can easily reel in the anchor rope using any of them. These handles make the boat very comfortable to carry for two. The bow handle is located below the fender for easy transport. It also serves as a towing eye.

The boat is equipped with spray gussets at the corners between the rudder tube and the rear wall of the transom. These gussets help to deflect the splashing water that occurs when the boat is in reverse.

The end and sides of the fixed transom are protected by pads. These pads protect the inflatable boat from mechanical damage caused by the motor.

All wooden elements are made of moisture-resistant marine plywood, either Russian or Finnish. Hardwoods are used throughout, including oak, acacia, and birch.

This model of our boats is officially registered with the Register of Shipping and Steamship Lines of Ukraine, meaning it has passed all tests. It is certified as a small vessel.

The basic kit includes:

- Inflatable boat
- Packing bag
- Slatted flooring, adjustable
- 2 seats
- 6.5-liter foot pump
- 2 oars
- Repair kit
- Technical passport with warranty card
- Small craft certificate